What nails should i use for vinyl siding

Dark vinyl siding is better than ever with new technology. How do you stagger vinyl siding? Stagger the siding end laps so that no two courses rows of panels are aligned vertically, unless separated by at least three courses. What is F channel for vinyl siding? The F-channel is a thin vinyl strip that is sold where siding is sold.

The upside down F creates a shelf for the soffit to slide into and rest on. The F channel can be easily confused with the J-channel that is used to cover the ends of the vinyl at the corners of the house and around windows. Can I install vinyl siding myself? While vinyl siding is not for everyone, millions of American homeowners have decided that it's exactly right for them.

The truth is, the price of a vinyl siding installation can be cut nearly in half if you're willing to do the work yourself. Can I use roofing nails for siding? James Hardie's website has instructions on their website how to install their siding using roofing nails or a roofing nailer. The nails are attached above the exposure line. Do you nail J Channel tight? It will look just fine and function as it should. I promise everybody's home you can see out of your front window with vinyl siding is done exactly as we have told you.

J-channel should be nailed tight. Do you nail vinyl soffit? You may also need to face-nail the fascia. Always pre-drill holes into fascia and do not nail tight. Oil canning, which looks like wrinkles in the siding, happens when the siding is installed improperly by either nailing too tightly, positioning the nails incorrectly in the nail slots or not leaving enough expansion room in receiving channels such as corner posts and J-channels.

Once a siding panel is oil canned it will have to be replaced. This is the industry standard for vinyl siding. For example, some sidings are thicker than others, which can increase impact resistance and rigidity.

Some sidings have a higher profile height than others, which can also increase rigidity. Added rigidity can help provide a straighter installed appearance. Some sidings have different windload resistances, as well.

Typically, thicker sidings with taller profile heights and higher windload resistances are more expensive than thinner sidings with lower profile heights and lower windload resistances. Finally, you should be certain you hire a quality, insured siding contractor. Ask for references and to see examples of his or her work. Find out if they guarantee their work. We warrant siding against manufacturing defects, but do not warrant installation. You may also want to check with the Better Business Bureau to see if any complaints about the contractor have been registered.

If you expose your vinyl to an excessive heat source such as an open flame or if you place a hot grill against the wall, it will sag and possibly even melt. We recommend watching an instructional video and reading our installation manual closely. Be sure to follow all directions carefully. Remember, improper installation can void your warranty. To install siding over existing hardboard or wood siding you must use furring strips. This will act as a flat surface to nail your vinyl.

You may wish to use an insulated sheathing between each furring strip. All panels should move freely under the fastener to allow for the expansion and contraction caused by temperature changes. Vinyl siding should be installed in accordance with the installation instructions supplied by the siding manufacturer. Staples and nails must be resistant to corrosion, such as cadmium-coated, galvanized steel, or aluminum varieties.

Staples should be at least gauge and semi-flattened to an elliptical cross-section. Power fasteners are designed to operate at specific air-pressure settings. Test the gun, your air pressure, and your usage technique on the first course of siding. Then, make the required adjustments or changes so that the following conditions are present on all panels fastened:.

Place fasteners at every stud or at a maximum of inch spacing into solid substrate. Make sure the panel is loose so that it can move freely in a lateral direction. Don Vandervort writes or edits every article at HomeTips. HomeTips articles may contain links to Amazon.